HOW TO REPROGRAM GARAGE DOOR OPENER REMOTE

STEP 1:

Check your garage door opener remote’s battery. Change the battery if needed. Make sure that the garage door opener is plugged in.

STEP 2:

Close your garage door, make sure it is closed all the way down.

STEP 3:

Carefully remove garage door opener’s cover that is over the circuit board. Once you reveal the components under the cover, find the ‘learn’ or ‘smart’ button.

STEP 4:

Press and release the ‘learn’ button. You will see a led lights illuminates. Now you have 30 seconds to program your remote.

STEP 5:

Find the button on your remote that you wish to program. There are usually 2 or 3 buttons on a remote. You can program each button with different garage doors, gates to properties, or even gated entrances to communities.

STEP 6:

Push the button you wish to program and let go. You will see the light on the garage door opener flash on and off, meaning that the remote is now programmed. It will not change the programming of the other remotes that are already working, the garage door opener simply learns a new code for the specific remote.

STEP 7:

Test your remote to make sure it opens and closes the garage door by pushing the button you programmed.

Comments for this post are closed.